ARC Performance
1932 Ford Steel 10 Gallon Fuel Tank

Tank is supplied with
Stainless Fuel Cap
Pick up assembly
Fuel sender unit with Ohm range of 240 empty and 33 full
Fuel drain bung

Our steel fuel tanks accept aftermarket sending units and are an easy bolt-in installation.

The provison for sender suits typical aftermarket 5-bolt senders ( VDO, Stewart Warner, Auto-Meter etc)

Bolt-in pickup assembly has three outlets:

• one for pickup
• one for return
• one for vent

Sender Unit:

Float style
Fuel sender unit with Ohm range of 240 empty and 33 full

Tank:

• Tank is approximately 38-3/4" wide including perimeter flange
• Overall length front to rear at the widest point is 15-3/4", including an extended flange area on about a third of the front edge for an additional 3/4"
• Majority of tank depth front to rear is 15"
• Overall height is approximately 9"
• Filler neck is welded in at the stock location

Perimeter Flange:

• The perimeter flange is designed to lay on top of the rails and has two mounting holes on the driver's side that are approximately 7-3/8" center to center and in from the edge about 1/2"
• There is additional hole marked, but not punched, between these holes
• On the passenger side, there is one mounting hole and two marked holes at the same 7-3/8" spacing as the driver's side
• The rear flange drops straight downward about 1-1/4"
• The extended front flange has two 3/8" attachment holes pre-punched
• Remainder of perimeter flange is approximately 1" wide and the mounting holes are in 1/2" from the sides

EXCLUDED FROM FREE SHIPPING DUE TO BULKY SIZE